Automatic Face Mask Making Machine Medical Mask Making Production Machine

Application:

The automatic mask body machine is mainly used for the automatic forming of flat masks

Machine Parameters:

Equipment Size:6500mm (L) x 1100mm (W) x 2100mm (H)

Production Capacity:100 ~ 120 pieces / minute

Rated Power:4KW

Working Voltage:AC220V, 50 / 60HZ

Machine Weight:1600 KG

Compressed Air:0.5-0.7Mpa

Operating Environment:temperature 10-35 ℃, humidity 5-35% HR, no flammability, corrosive gas, no dust (cleanness no less than grade100,000)

Description:

This production line is a fully automatic one-to-one mask machine, one body machine drives two ear band machines. After the main body machine outputs the mask body, the mask body sheet is conveyed to the turning mechanism by the conveyor belt structure, and the mask plate is turned to the conveyor belt connected to the ear band machine through the turning mechanism, and then the mask sheet is conveyed to the ear band machine through the conveyor On the front of the first mask plate, finally, the mask sheet is placed into the mask plate of the ear band machine by pressing down by the air cylinder. The ear band machine then completes the welding of the ear band of the mask, edging, etc. to complete an ear band mask. Production of products.

Selling Points:

High stability, low failure rate, beautiful appearance without rust

Computer PLC programming control, servo drive, high degree of automation;

Photoelectric detection of raw materials to avoid mistakes and reduce waste.

The main conveyor adopts single-phase motor for conveying, and the stepping motor is turned over. The transmission is precise, the control is stable, and the speed is adjustable.

Features:

The top layer, filter layer, and bottom layer of three rolls of fabric are automatically aligned and fed.The two sides are continuously rolled by the ultrasonic system.The nose clip is automatically cut & fed into the underlying fabric, and the first step of pressing and merging is cut into a single fabric at the same time;

After the lamination is completed, the conveying line is sent into two automatic welding ear belt devices in a one-to-two manner;

Photoelectric detection of raw materials to avoid mistakes and reduce waste.

The main conveyor adopts single-phase motor for conveying, and the stepping motor is turned over. The transmission is precise, the control is stable, and the speed is adjustable.

Specification:

Equipment Size	6500mm (L) x 1100mm (W) x 2100mm (H)
Production Capacity	100-120pc/min
Rated Power	4KW
Working Voltage	AC220V, 50 / 60HZ
Machine Weight	1600 KG
Compressed Air	0.5-0.7Mpa
Operating Environment	temperature 10-35 ℃, humidity 5-35% HR, no flammability, corrosive gas, no dust (cleanness no less than grade100,000)

Samples: